Raspberry Pi NoIR Camera V2 (must be wired to be powered from the 3.3V and GND pins. V2 camera does not have metal contacts on the board like V1. We recommend the V1 camera for these lights because no wiring is needed.)
Onboard light sensor (The LEDs will only turn on when it is dark out to conserve energy)
Potentiometer onboard for adjusting the ambient light threshold
When the light in the room is below the ambient light threshold, the LED will be on.
Takes power from the Raspberry Pi's power supply so heatsinks and / or a cooling fan are recommended to dissipate excess heat created from the 3W high power drain.
The screw holes are used for both mounting and power supply! No extra wiring necessary!
Ideal imaging distance: up to 9.8 feet (3 meters)
When the distance goes up to 6m, the night vision camera can just capture blurry outlines.
Includes:
2 Infrared LED Boards
5 Screws
5 Nuts
1 Adhesive Pad
Instructions:
Connect the Infrared LED Boards to the left and right of the camera PCB with the screws
Adjust the potentiometer to set a proper ambient light threshold, which toggles the infrared LED ON/OFF automatically
TS2070
3 Items
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.